I have a slightly damaged crankcase cover for sale. It is off my 2006 FZS6V(C) so it has the needle bearings already installed, but three parts on the inside are damaged. All the internal damage is on the support lattice and I would be happy to explain in more detail the condition of the part...
So I went ahead and got a EBC SRK clutch kit and tried to install the clutch tonight. Yea, it's completely toasted. The part that bugs me is that I installed the new plates and springs, but with the springs tightened all the way down there is about 1cm play in the plates. Does anyone know if...
I don't normally launch hard during day-to-day riding, but at the drag strip I try to launch at 10K rpm and slip the clutch. When I say that I am "abusing" my clutch, the 10K launches are what I am talking about. I would like to take her to the drag strip and track for many years to come, so...
Hey all,
So tonight I was abusing my clutch at the local drag strip and noticed a squeal below 4K rpm.:( It happened at first when I was slipping the clutch to do a burn out, but now it happens whenever I take off from a stop. This was my fourth time at the drag strip and I did some hot laps...
Unless your bike runs less than an 11sec 1/4 mile or has a trap speed of 120mph or faster, then you don't need full leathers. At Bandimere you need denim jeans, a good leather jacket, good leather gloves, boots that cover the ankles, and a DOT and SNELL approved helmet. If you have all of the...
Hey all Denver/Plains riders,
I am going to be heading out to Bandimere on August 4th and IMI motorsports on August 10th. Both cost $30 and are a great way to test the limits of your bike.
Thanks for the replies! I know I need to work on my technique and that's what track days are for! As a buddy of mine says: "Ride hard, ride fast, don't crash"
Hi all,
Recently I was riding my favorite twisty and I think I scraped my foot peg. I know I hit my toe slider, but I am a little weary about my foot peg. I have already removed my peg feelers and center stand because the last track day I was grinding the feelers to a pulp. Does anyone know...