I have had a start and run for a while but stop and restart again and repeat. Turned out to be a fuel pressure problem due to a fault in the pump. The pump ran electrically ok but was not quite right in its assembly. You can easily check pump pressure with pressure gauge. Make sure pressure is...
My FZ6N is a going concern. Very good. It's a little small for me so I'm about to lower the footpegs, raise the bars and probably fit a fairing of some sort.
Looking at my FZ6 after a while. Need a road worthy certificate in Victoria Australia.
Change after market muffler to something big and fat. Thinking about lowering the footpegs for a bit more leg space.
Thank you for the heads up on my issues with get the FZ6 going. I will have to leave it for a month as I have other things I must do. Thank you for the manual most recently. I must confess manuals arrived earlier, my Monday about midnight. I didn't realise what I had.
So, on the crank position...
FSM not yet received . Please send to [email protected]
That would be great
My problems are Fault Codes 12 and 13
12 I understand I will need to remove the Crank Position sender to examine it for wear as I understand this component can apparently wear out(??)
13 For Do3 I have a reading...
When you look at the Error Code listing there are a dozen error codes that do not allow the engine to run. It's essential to get the instrument panel going again to see what the error codes are. I'm finding a schematic or wiring diagram not easy to get. For myself, I've ordered a Haynes manual...
Hi MrPrim3, Would appreciate a service manual and operators manual plus any info on a wiring diagram. I have a 2007 FZ6. Email address is: [email protected]
Hi Norbill, I think you clutch is fine. When it is released in Neutral the gearbox is idling and the gears are turning. That is the sound you hear. When you pull in the clutch lever the gearbox is disengaged ie. the gears have stopped going around.and the sound goes away. The cause is probably...