Ruggybuggy
Member
- Joined
- Apr 21, 2012
- Messages
- 415
- Reaction score
- 6
- Points
- 0
- Location
- Northern Ontario, Canada
When I first went to mount my LED turn signals I soon discovered that after removing the stock signals it left large tear drop holes and no way to mount the custom signals. I posted my problem and was told I need new mounting brackets. I came up with a solution using the existing parts from the stock signals.
Here are the stock parts to be used.
Cut the end off the stock turn signal so it looks like the one in the picture. I cut just above were the rubber bulges then used my bench grinder to smooth it out. Modify the plastic piece by removing the two plastic tabs so they are flush as shown in the photo. Sorry for the blurry pic.
The two pieces will fit together as shown.
Remove the two rubber tabs so it looks like this.
This what is looks like installed.
Thead the plastic part onto your turn signal.
Install onto the bike.
Use a large stainless steel washer along with your existing mounting nut.
Secure in place
The final result. This works on the front as well.
Here are the stock parts to be used.
Cut the end off the stock turn signal so it looks like the one in the picture. I cut just above were the rubber bulges then used my bench grinder to smooth it out. Modify the plastic piece by removing the two plastic tabs so they are flush as shown in the photo. Sorry for the blurry pic.
The two pieces will fit together as shown.
Remove the two rubber tabs so it looks like this.
This what is looks like installed.
Thead the plastic part onto your turn signal.
Install onto the bike.
Use a large stainless steel washer along with your existing mounting nut.
Secure in place
The final result. This works on the front as well.