Recent content by rcruz17

Yea thats what I bought on ebay. If you want to email me [email protected] i can send you pics faster than trying to attach them on my phone. If not wont get to a desktop until sunday.

Yes the only thing it doesnt have is the electrical connections I also have an FZ6 ecu that came bundled with the coils i purchased.

I reinstalled stock muffler and shes back to normal...

Re: FS: rear frame assembly W/O rear footpegs i have an 05 :( i always feel like I got the inferior model

Re: FS: rear frame assembly W/O rear footpegs um can you explain what this helmet lock tab is? I didnt know I had a helmet lock tab?!

still looking I have my front ones but no wires though.

This is the video after changing the coilpack, nothing else was changed at this point. https://www.youtube.com/embed/I-8sHXuef7I In this video all I did was plug up one of the mufflers. https://www.youtube.com/embed/Wpzo5dGaf0U

So I just fixed bike or at least found a new problem? So i just put a new coil for cylinder 2+3 and fired her up and noticed a change in the exhaust note, it was no longer surging every few seconds it was now more consistent. Im at my buddys garage so i took his dirt bike exhaust plug and...

Ok i actually didnt even touch them just measured them all and they were at 0.8mm whichwas within spec so installed them like that.

Ok so my gap is at 0.8mm does co value reset when battery is unplugged? If not mines should be at +35 still

The new throttle body assembly came with a TPS which was from an 06 from my understanding that one had no recall therefore no issues. I replaced the spark plugs with CR9E and gapped them to what my sticker in swingarm. .8 something i forget what the measurement unit was. I just turned on bike...

I synced the throttle bodies at 8 inHg. bike idles ok but it still stumbles and surges at idle and while driving. I replaced the throttle body assembly with fuel injector and fuel rail in case it was an injector issue and bike behaves the exact same way as it did before so Ive discarded the...

I think i have achieved that balance she idles at 1300-1320 spot on smooth she revs up good...but if i let her idle long enough i can hear she stumbles and spikes up in idle....how can i verify coil pack and injector function?

Ok my tb sync settings were at 8.6 that that was near all screws closed up? #4 was all the way in at that point. Also input co at -20 and she was idling super low around 900-1000. Ive noticed my main issue is when she starts sounding bad and idle spikes. Around 26 seconds on my latest video...

Hmm ok so i wasnt to make the vacuum hose connection bigger or smaller? Ill redo it tomorrow morning. So i want to set them at 8.6 or aim lower? Should i be doing this with co at +25 or go back to the stock numbers?