Flashing check engine light

Cocoloco

Site Supporter
Joined
Dec 12, 2021
Messages
187
Reaction score
113
Points
43
Location
Manila philippines
Visit site
Good day!
Im having problems with my bike, this is the first time ive ridden my bike after i disassembled at cleaned everything

The check engine flashes and the power cuts when i opened the throttle fully it wont rev past 8k rpm
 

Cocoloco

Site Supporter
Joined
Dec 12, 2021
Messages
187
Reaction score
113
Points
43
Location
Manila philippines
Visit site
Bike history
New fuel pump motor
New fuel filter
New fuel
New airfilter
New sparkplug
New battery
I've just got the bike running after re-assembly
Im thinking ignition coil leads and wires but ive just snipped some wires and reconnected it.
Still my headlight is not turning on after i reconnected cut wire
 

Gary in NJ

Junior Member
Site Supporter
Joined
May 6, 2014
Messages
1,964
Reaction score
1,908
Points
113
Location
Amoungst the Twisty Roads
Visit site
If the check engine light flashes, there has to be an corresponding error code. You should be able to view the code when you turn the ignition key to the on position, before engaging the starter button.
 

Cocoloco

Site Supporter
Joined
Dec 12, 2021
Messages
187
Reaction score
113
Points
43
Location
Manila philippines
Visit site
If the check engine light flashes, there has to be an corresponding error code. You should be able to view the code when you turn the ignition key to the on position, before engaging the starter button.
Ill try it again tomorrow , no check engine light and error code appears ,
 

Motogiro

Vrrroooooom!
Staff member
Moderator
Elite Member
Site Supporter
Joined
May 8, 2008
Messages
14,968
Reaction score
1,138
Points
113
Location
San Diego, Ca.
Visit site
Also check charging voltage at 3000 rpm. Higher than 14.7 vdc. is not good. Low volts are also no good.
 
Top