BlackAndBlue
Junior Member
I am running hellgates map on my all stock 07 now and it is definitely way better than the 04 map that power commander provides for download. My fuel efficiency went up roughly 40% and throttle response is much smoother.
Just remember if you install new/used fuel controller; connect it to your PC and set/verify your TPS values SPECIFIC to your bike before running around town.
I am running hellgates map on my all stock 07 now and it is definitely way better than the 04 map that power commander provides for download. My fuel efficiency went up roughly 40% and throttle response is much smoother.
You mean the PCIII unit itself? That may never have been done by the p.o. it seemed pretty good when I did look at it initially though. It was 0 when closed and showed 5 on very little input. I didn't check WOT though. So you're saying if it is right now then I don't need to check it again of I switch to a different map?
The power commander has a slightly different way of reading (it gives some arbitrary value instead of a TPS voltage reading). You can reset the TPS values on the power commander III by plugging it in to your computer and choosing "Power Commander Tools -> Set Throttle Position". Keep the throttle completely closed, and chose to reset the values. It will set your zero point, and then open the throttle smoothly to WOT and it will set your max point.
Can you send me that map? I'm getting around 30mpg on my 2010 fx6.I am running hellgates map on my all stock 07 now and it is definitely way better than the 04 map that power commander provides for download. My fuel efficiency went up roughly 40% and throttle response is much smoother.