Recent content by Herman

Hi Gary I will try the above. Initially when the bike did not start I did basic trouble shooting. 1. Replaced battery with new one. (I trickle charge it every weekend and after I worked on the bike) 2. Drained fuel and added fresh fuel. 3. Checked oil levels. 4. Checked if fuel pump is...

If the Kill switch is off (X) the bike does not crank If the Kill switch is 0n (O) the bike cranks ( engine turn I bought the bike new in 2006, no mods, not even the pipe. It has 37 000km on the clock and I took it for a service every 5000km at a Yamaha dealer, last service, 35 000km. (As I...

Apologizes for the late reply, things came up and I had to leave the bike problems for a while. @Motogiro I unplugged the ECU and both the lean angle sensor plug and crank sensor plug. Tested with a multi meter and both had continuity (Beep). Lean angle sensor > Blue wire, black and blue...

Hi Ohendo I tried it again. 1. In diag I go to d61 and it shows 30 and 12 2. Then I move to d62 ( Shows 2) switch kill switch On and Off 3. Nothing happens 4. Switch bike off using key 5. Go back into diag still the same d61 30 and 12, d62 shows 2 I tried it with the Red Motorcycle key and...

I measured crank sensors ohms and it measures within range 285ohm. (Info from a You tube video) I spoke to a fellow Fazer owner who had a similar problem, code 12 in d61, he also could not clear the code and his bike also did not start. He had the sensor replaced and his Fazer still showed...

Hi Ohendo I tried your method, as per service manual, see post 20th June. It does not clear the codes.

I took the battery out and put it on a trickle charger for 2 hours. Replaced the battery and went straight to Diag mode. Fault codes still the same, they did not reset. I checked the lean angle in Diag 08 and it was 0.7 within spec. (my paving is slightly skew)

I found another FZ6 and checked the Diag mode. d20 is the side stand switch Side stand open (bike on stand) d20 = off Side stand closed (bike of stand) d20 = on Checked the plugs, no spark in d61 I get a fault code 12 and 30 Fault Code 12 = No normal signals are received from the...

I found a link on how to go into the diagnostic mode and found the following. All modes are correct except side stand switch. No error codes d20 - on - Stand status (it does not change to off if I open or close the side stand.) So I did the following. Open the stand switch and bridged...

Hi Gary I am not very mechanically minded and don't want to "dig" to deep into my Fazer. I did empty the tank and changed the fuel

My Yamaha Fazer FZ6 (2006) has been standing for a while. I replaced the battery but she won't start. The starter turns but the bike does not fire Immobiliser light goes off when I turn the ignition key and the display lights up. Opened and checked stand switch. I can smell petrol/gasoline if...