Recent content by okle001

hi yeah its never done it before until i installed aftermaket exhaust

As above. installed dominator exhaust and am happy ie. much better than stock exhaust but have noticed it back firing when I accelerate hard then decelerate, never had that problem before. Any advice Thanks

It was the orange lead that was fried. managed to pull apart and I know sounds dodgy, soldered a sewing needle. I have ridden the bike for about 2hrs with no probs

thanks. the female port is blocked off with the connector it looks like it has been fried but may be able to clean it out.

As above my ecu had a burnt contact. Are they easy to replace? ie plug and play

ok have just got my new coils and installed, started bike no problem ran bike for approximately 10-15mins turned off and problem remains. error code 34 and bike alomost stalling and running on 2 cyl. the strange thing if i start my bike cold i can ride as normal, as soon as i shut down and...

Thanks have taken apart and cleaned and will test with a meter

hello just after some information on this code. my bike runs fine until it gets hot, when i turn off and go to start again it sounds like im running on 3 cylinders, power is reduced significantly and will stall if i dont hold revs up. from what ive read 34 means the coil going to 2nd cylinder is...

soldered old plugs onto new one, all seems to be working thanks

thanks for reply. like i said it seems theres same wires and colour but just wanted to ask first thanks. where might i get adaption plugs from. thanks again

hello, am just after some advice, i have many dead pixel on my speedo. so i bought a second hand display from the UK (im in Australia) my original display has 3 plugs: 1 with six wires 2nd with four wires 3rd with one wire the one from the UK only has 2 plugs 1 with six 2nd with...