Recent content by HarmfuL

So i recently bought some Yamaha LED Indicators for my bike and started off by installing the rear set first (being bit more tricky I thought). The blinkers come with a resistor so the flasher relay didnt need to be replaced. I tested them and they worked fine on the rear, then installed front...

So i recently bought some Yamaha LED Indicators for my bike and started off by installing the rear set first (being bit more tricky I thought). The blinkers come with a resistor so the flasher relay didnt need to be replaced. I tested them and they worked fine on the rear, then installed front...

Thanks do you no which wires would match which? My new indicators have Black & Yellow wires

Cheers Ive just sorted it and found the spares :D all lights are working now Just another quick dumb question..As my new Arrow Indicator wires are too short, should i buy these??? INDICATOR CONNECTOR LEADS GREY BLOCK SUZUKI/YAMAHA TYPE: Amazon.co.uk: Car & Motorbike INDICATOR CONNECTOR...

Thanks a lot ! I shall go out now and try this My wiring is correct I just think I misplaced a wire with another and that blew the fuse. Would you no if there are any spares on the bike? My old XT came with spare Cheers

Hi peeps just had a bit of a nightmare with my new Arrow Indicators I just bought.. Firstly, as I have an EvoTech Tail tidy (which has the same shape as the original fz6 tail, just smaller) the Arrow Indicators have a threaded rod on the end so will not fit within the indicator holder on tail...

Thanks Greg for much help :D

Ok cheers! ts just looks like the wires wont disconnect because they are enhoused within a rubber seal, but they will defo ome apart without ripping the wire in 2?

I am having a few problems installing my new Tail Tidy kit from Evo tech. Firstly there are 3 wires leading from the standard Tail ( 2x indicators and No.plate light ) and the indicator leads disconnect but the No.plate light divides into 2 wires, both cant be disconnected..Im just wondering...