Search results

This all seems so long ago. The bike has been faultless and enjoy it for two up ride out's. Cheers and safe riding

Thanks for the replies and apologies for the slow response. I finally got physically more able to sort the issue out and actually got out on it for the first time yesterday. Having tested and removed all other possible issues I sent the ECU off for testing and it was stuffed, A word to the...

Good feedback, Yes yellow/blue Thanks for clarifying. I'll revisit the shutoff circuit (previous test, I believe, 2ohm - test lead resistance) can't see where i scribbled that one down. Need to purchase/rig up a 12v lamp test for the remaining tests. Back when completed Again thanks for the...

All four fired. Slight warmth to down pipes After on starting, the initial check clears on the clocks and on start engine warning light comes on and cylinders 1,4 not firing. Runs on 2,3 Just to verify primary coils resistance 2ohm secondary 14.53, 14.77kohms caps at 9.5kohm Battery maintains...

Thats a yes to all four plugs. New plugs installed too. I'll get onto the fuel sugestion and update to verify firing plus earth path. Diagnostic code 62 "malfunction code reinstate" i believe this would not reinstate while a fault condition exists.

Hi, sorry for the frustration. Still get really bad days so can only do occational visits. Please move on from the battery (Electrician predominantly DC environment) Bike cranks over trys to start, cylinders 2,3 exhaust cool. Both coil sets new, a failed cap replaced Able to run onboard...

Thanks for the replies. As the basics have been covered it's components that effect the return path to give this 5.3v on display. Although the bike won't tick over due to loss of cylinders, cranking is not an issue or loss of ignition to any cylinders. So protection mode but no fault codes...

Became another statistic of car vs bike.(Not the FZ) 4 months later back to trying to get this FZ sorted. Display reading just over 5volts.when in diagnostic mode 9 Battery charged and tested, Kill switch continuity fine. First time this has occurred and previous issues aside, finally got it...

Thanks for the response. Seems to come in at temp rise, will try again tomorrow and see if it repeats itself.

Not sure of the connection method on a FZ yet but had issues with Honda clocks and eventually found circuit contact relied on the screw fixings into the base of the clocks, rust build up on the spring washer preventing contact. Hopefully a better design on the YAM Sat with a magnifying glass...

Hoping to sort out this issue, Initially a none running bike. Side stand wiring issue sorted and ran. Produced intermittent failure on 1st and 4th cylinders. Ran the on board diagnostics with two fault codes in history. 22 and 33. Diagnostics test ok on 22 (Air intake sensor) history cleared...

Hi all, Andy living in Perth WA. Just purchased a none running 2007 FZ6 which has issues, so a good look on the forums to hopefully sort it out. Got it running in 10mins of getting it back. Now the real fault finding skills start. The bikes for my wife (and the occasional try outs for me, love...