correct

This nifty little device works great to correct the speedometer. You can get exact calibration when changing sprockets. I changed front sprockets using both 15T and 17T - this is just what was needed to have the speedo be correct. - Physical installation is achieved via simple unplug of...

Hey guys, just wondering who has swapped out for an APE cct and double checking model #. APE doesn't list the FZ6 on their model list, but the 99-05 R6 uses their YT1000 model, so I'm guessing that's the correct one? Since I have access to a shop this month and have another week or two down...

I have had pretty mixed results ordering OEM and aftermarket parts from several vendors and through dealers for my 07 FZ6 (and Kodiak ATV) Can anyone recommend a parts supplier that will consistently: 1) send the correct part as specified by me? 2) send the part in less than 30 days? 3)...

I recently bought a new set of Conti Motion tires for my 2009 FZ6. The tires are mounted correctly with the rotation arrows on the sidewalls in the correct direction. I noticed that the sipping on the rear tire run one way but the sipping on the front tire runs in the opposite direction. The...

Hello fellow riders, I turn to you for hope! My Fz6 '05 doesn't run smoothly. It's been staggering for a while, and I've had some problems with power loss, and rough idling with drops from 1300rpm to 900rpm, and even stalling on idle. (VIDEO OF PROBLEM) I've fiddled about for a while now...

Hi, I picked up my barn find 2005 FZ6 and have been hunting on here for anything about adjusting the chain. Ive found some threads about cleaning the chain and the correct amount of slack, however I was hoping an experienced owner could post a how to for chain adjustment. My bike did not come...

I finally received the parts I ordered from Babbits and the nuts are different than the ones I took off, but it look correct on the diagram, any ideas? Ryan

Hey folks, Been kept away a while with work but back now and looking to get the bike good to go! I fitted HEL brake hoses yesterday but have a few queries and thought you knowledgable folks could assist. A picture paints a thousand words so I've attached some. I'm fairly confident...

Hey guys, my wheels seem to be offset but the alignment is good. I replaced both tires about 500 miles ago myself. Obviously, I pooch screwed something on reassembly or didn't get everything aligned. Assuming all spacers/washers/bearings are in the correct location, any ideas on how to...

Hi, just been cleaning my throttle tube and lubing cables and general cleanup as I was experiencing binding which turned out to be the rusty bars, cleaned and greased, all good. I checked the open and close cables worked ok and sprayed in a bit of WD40 for good measure, they were opening and...