flush

Looking for creative ideas for the right side (looking at bike head-on) mount, are people mostly taking the triple off and tapping that hole where the outline is? I'm not opposed to this but it's a decent amount of work so I wanted to see first. Anything else I can do that works? I mounted it...

Imgur: The most awesome images on the Internet I had to flush four times before the water came out clear. The gallon you're looking at is the original coolant + one distilled water flush. I replaced it with engine ice. Things to note now : Bike runs much cooler, about 10 degrees...

So, I did a brake flush today. But I think I may have messed it up ? I attached the speed bleeding kit to the speed bleeder valve on my front right brake and then opened the valve, and pressed the front brake to pump fluid through the system. I pumped until the reservoir was low then I topped...

Hey guys, I'm here looking for a little advice. I'm fresh off of a totaled out yzf600r and looking for my next bike. Think I've pretty much narrowed it down to a FZ6 or FZ1. One of the ones I'm looking at is an 08 FZ6 with 31k miles for $2500. Owner says its been dropped at a stop and fairing...

Its a 2006 with 19k on it, purchased with 12k this April- runs perfectly. I'm thinking: -Plugs (NGK (3521) CR9EIX Iridium) -Air filter (I believe it has a K&N but I'd like to go stock) -Brake fluid flush, replace caliper seals -SS brake hoses -Coolant flush -Buy the tool for TB sync and...

Did some searching but couldn't seem to find it I'm hooking up some flush mounts on the front and I know the power drl and ground but my question is: if my flush mounts that I bought came with 2 wires is there a way to get it to work? When I put the blue to the power it makes my back ones come...