F/S FZ1 bar w/ stock FZ6 bar ends

[Bill]

Stock, black engine wrinkle power coated FZ1 bar and stock FZ6 bar ends. $20
I'd like to help out the site and donate the sale to the forum.

Send Dennis (Admin) the money and when he receives it I will send the bar and bar ends. U.S and Canada only please. Unless of course you would like to pay for international shipping then I'll ship them anywhere. My zip is 17407.

Also for sale K&S bar ends. $5
Same deal as the bars.

 

[parallax]

Stock, black engine wrinkle power coated FZ1 bar and stock FZ6 bar ends. $20
I'd like to help out the site and donate the sale to the forum.

Send Dennis (Admin) the money and when he receives it I will send the bar and bar ends. U.S and Canada only please. Unless of course you would like to pay for international shipping then I'll ship them anywhere. My zip is 17407.

Also for sale K&S bar ends. $5
Same deal as the bars.

I'll take the bars, will get with you after I touch base with Dennis.

Anthony

 

[Nappa]

That's a steal. The stock bar ends go for almost $40 each!

 

[Bill]

I'll take the bars, will get with you after I touch base with Dennis.

Anthony

FZ1 Bar Sold! :thumbup:

Still have the K&S bar ends.

 

[Bill]

That's a steal. The stock bar ends go for almost $40 each!

That is a shame isn't it? $80 for a set of stock threaded bar ends. Bought a set of HVMP X-Heavy stainless bar ends for $80 shipped to my house... Anyway, problem is I will never use them again, and they are used. So maybe if parallax isn't going to use them... he could re-sell them and donate that sale back to the forums? Or maybe pay it forward?

 

[7UPyours]

did you use the K&S bar ends? Did you notice big difference over stock

 

[Bill]

did you use the K&S bar ends? Did you notice big difference over stock

Sure did. Had them on for a couple of days. And yes I did notice a difference. I noticed more vibration at low rpm's, but I'm kinda use to vibrating handle bars from my V-Rod... However my wife didn't like it with the new bar so off with the K&S ends. I didn't want to fill up the new bar with lead and or caulk to cut the vibrations.