Uhm - FZ or R6? Was thinking it was R6? Bushing install is the same...
Look here:
1 Outer tube bushing. Needs driven below ridge at #3.
2 Inner tube bushing. Drops into tube 1st.
3 Outer tube bushing landing. #1 must seat on the lower ridge.
4 Seal landing and snap ring landing. Snap ring grove barely visible.
Hope this helps. PS I don't recall any bevel shaped washers. Any else one been here recently?
Look here:
1 Outer tube bushing. Needs driven below ridge at #3.
2 Inner tube bushing. Drops into tube 1st.
3 Outer tube bushing landing. #1 must seat on the lower ridge.
4 Seal landing and snap ring landing. Snap ring grove barely visible.
Hope this helps. PS I don't recall any bevel shaped washers. Any else one been here recently?