GravisMaximus
Junior Member
i would like to know if any of you know if the engine bolts used (where you mount the sliders)on the fz6 are the same size diameter bolts as the ones on a R1. i was looking to get a set of offset sliders due to my Yamaha fairings (i dont want to cut them) and have run into these. YAMAHA YZF-R1 2007 FRAME SLIDERS POLISHED ALLOY:eBay Motors (item 280389964773 end time Sep-25-09 17:53:48 PDT)
the other question is- if you look at these offset brackets you see the tits sticking out, which fits into where the engine mount bolts go. is this also the same size hole between a FZ6 and a R1?
i have also seen a set at graves motorsports Graves Motorsports - Graves Motorsports Frame Savers Yamaha R1 (2007-08)
that have fins that stick out so the bracket cant rotate, but there a bit more and the final queston would be do you think these R1 graves sliders would fit over the FZ6 frame?
thanks for the help in advance :Flash:
the other question is- if you look at these offset brackets you see the tits sticking out, which fits into where the engine mount bolts go. is this also the same size hole between a FZ6 and a R1?
i have also seen a set at graves motorsports Graves Motorsports - Graves Motorsports Frame Savers Yamaha R1 (2007-08)
that have fins that stick out so the bracket cant rotate, but there a bit more and the final queston would be do you think these R1 graves sliders would fit over the FZ6 frame?
thanks for the help in advance :Flash: