leds

  1. M

    Led relay problems

    Okay, I swapped the front turn singals and headlight for leds. I replaced the rear turn signals with sequential turn signals(leds) and yes I replaced the flasher relay with one for the leds. Now here's the weird part I'm struggling with. With the relay hooked up one way, the front signals flash...
  2. arronjackson

    LED Turn Signal Burn Out

    Hey forum, Wondering if I'm having bad luck or an electrical issue. A couple years ago I installed the Competition Werkes integrated rear turn signals. It lasted a few months before some of the LED's burnt out and then I experienced hyperflash. I replaced it and the replacement lasted nearly a...
  3. S

    Lost in headlights: single to dual, halogen to LED

    Hi all, I've just noticed Schoopce mentioning that H4 LEDs are plug and play with H4 halogens, which is great. I want to swap a set of 55/60w halogens for LEDs in these dual headlights (dominators) that I bought for my Fz6n (2007). I'm worried the dual halogens will draw too much from the...
  4. trepetti

    Looking for LED 1157 bulb for tail light

    I have a Motodynamics LED tail light that the PO installed. It is the 'Smoke' tinted, and I am beginning to think that it is just not bright enough. Considering the tint and the somewhat 'directional' of the LED's, I am not happy with the light output. So the plan is to reinstall a regular...
  5. yesiwearjumpers

    Lights (Front running lights)

    Hi, Just bought a 05 FZ6 S and am looking to make a few improvements already. The first thing I would like to do would be to change the yellow running lights on the front of the bike. Ideally I would go for some super bright LEDs but I can't find any information about what sort of bulbs are...
  6. Koissu

    Daytime Aux LED Recommendations

    Hello All, I am thinking of adding some auxiliary LEDs to the front on my bike for increased visibility. I've seen mentions here and there but no real thread (point me in the right direction if I am wrong). I'm not the most mechanically/electrically talented person around but I am pretty good...
  7. E

    Flasher Relay on Project Bike

    Okay, so I'm well acquainted with the need for a flasher relay rated for LED's due to their lower power consumption etc. What I've been working on is my custom wiring harness for my project bike, a 1979 Honda CM185, its a 6 volt bike and I wanted to run LED turn signals and brake light, so...
Top