lmarchett
Junior Member
I bought a Motion Pro carb tuner to Sync the FZ6 and having a little bit of trouble.
1. The instructions call to install restrictors before tuning bit it looks like the completely block off the tube, should i still jam them in hook it up to the vaccume lines?
2. I did the sync without the restrictors and it seemed to work, but I was unable to sync throttle body #2. I had the other three sync screws screwed all the way in and #2 all the way out and number 2 was still off by 2 ticks on the scale.
The bike runs fine but i'm worried that were might be some larger issue @ hand here. Should I not worry about it or think about paying a shop the big $$ to look at it?
(2007 FZ6 Bike was bought used)
1. The instructions call to install restrictors before tuning bit it looks like the completely block off the tube, should i still jam them in hook it up to the vaccume lines?
2. I did the sync without the restrictors and it seemed to work, but I was unable to sync throttle body #2. I had the other three sync screws screwed all the way in and #2 all the way out and number 2 was still off by 2 ticks on the scale.
The bike runs fine but i'm worried that were might be some larger issue @ hand here. Should I not worry about it or think about paying a shop the big $$ to look at it?
(2007 FZ6 Bike was bought used)