Heywood
New Member
^^^
Good info (same as what I found way back, exactly) but your boots should go all the way down...
If you put some dielectric grease (very light coat) where the rubber boots meet the valve cover and a little inside the boot, they'll go on much easier and FULLY.
You'll actually hear the caps snap on. Their very likely NOT on fully and may cause issues.. Grease em up!!
I should have stated that I did grease the boots where they contact the plug but didn't do the covers. I was attentive to the snap to ensure the plug was engaged with the boot. I'll have to shoot a pic later tonight and post up. Runs great but seemed odd that the cap didn't seat fully to the valve cover.. I spent some time trying to diag but couldn't find anything wrong with the boot seating to the plug. I did some serious pushing and the boot doesn't go any farther. there is a raised ring on the boot that the cap fits in, I can always slide the cap down the boot just a bit or put that above the cap. Like I mentioned, pics to come.