fuse

Hi all, Could use some advice on a turn signal issue I am having. Yesterday I tried hardwiring led license plate lights. The previous owner had installed a fender eliminator kit and had the license plate lights wired and I figured it would have been easier to cut them off instead of...

I have recently bought an 06 naked FZ6 but when trying to get a live feed from the rear lights I must have accidentally grounded out something and now I have no rear light, no turn signals and no hazards. Taking off the rear panel there seems a bit of a dogs' breakfast that someone has made...

Hello - I am the proud owner of a "new to me" 2004 FZ6. Love the bike and it's in almost new condition - only 8800km. It came with a Givi V46 topcase and I decided to add this kit to it (V46 Top Case - LED Kit (TS)). I got it installed last night and got it working. Signals, brake...

Hello Guys So maybe you can give me a hand, I installed some HID's with angel eyes and LED strips and since then I get ERROR_1 when I shut the bike off. I only get error 1 when my battery is drained, and apparently is when the ECU is not getting signal, all the installation is ok, so I does...

Just finished installing the r1 forks on my 06 fz6 as well as a new radiator. everything was going smooth road her around for a couple errands. i pull into autozone because i saw that my dash was out. i pulled in grabbed a fuse and replaced it in the rear fuse panel. display didnt come back on...

Not been on the site for a while but thought after my last mod I would throw up a few words as there seems to be lots of threads online regarding what I did but few definitive instructions and answers which I needed. So this weekend I fitted a 12v socket to the FZ6. this is a pretty simple...

My tail/turning signal lights suddenly stop working. I checked the fuses and the only fuse that blew was the tail light fuse.Every time I replace the tail light fuse is blows. How could I find out where the short is coming from.

I replaced my battery on fz6 today. I had a few questions: While in diag mode the old battery registered 11.4 and the new battery registers 12.0. But when I put a voltmeter directly to the batteries themselves they measured 12.4 and 13.2. 1)Is the d09 sensor in diag known to be...

So I was on my way to work yesterday and after about 5 minutes or less of riding I suddenly lost cylinders 1 and 4, the whole bike then cut out about 20 feet after that which I think was due to the ignition fuse blowing. I got the bike home and took it all apart and started testing wires etc...

I was trying to change out my stock signal lights for some led ones, but I made the mistake of letting the wrong wires touch. There was a spark and the signal lights as well as the signal light indicator on the dash no longer come on. Headlights, brake lights and horn all work fine still...

So I went out tonight, haven't been on the bike in months (house burned down, lost all my gears). Anyway, halfway down the block I realize my headlight is out, I pull over, feel for the headlight connectors on both sides, both are on, high beam is also out. I turn around, come home and pull the...

Hi all, looking for VW guru's. At the collision center I work at we just repainted a mint condition 73 Super beetle with only 53K orig miles. When I say this car is mint, its truly MINT! Original owner and completely unmolested since new. Full service history since 73'. Original everything in...

First, low beam worked but high beam didn't. Then high beam went out to. Changed the bulbs (even though they didn't look burned out) and still nothing. Changed the fuse next (even though it still looked good) still nothing. Headlights still don't work :( What's next to check? Chaffed wiring...

I ordered some new Lockhart Phillips LED turn signals for the front of my '07 FZ6, and they just came in...I wanted to get started on the install, so I detached the left stock signal. For some reason, beyond my knowledge, I tried turning the flashers on with the signal unplugged, and it flashed...