plug

I've been meaning to do this mod. I don't mind splicing/soldering. Every time I look up the process is get discouraged because the posts are so old and do not have pictures. I'd prefer to have the method that disables the lo-beam filament when I put on the high beam. From what I can tell...

I am currently looking for a headlight for my conversion, I am looking at a round single 7" headlight. I would like it to be as simple as possible(i'm no electrician).As far as I understand the 06 fz6s is an h4 bulb with hi low. Is it as simple as finding another h4 headlight with hi/low and...

Sorry if this is in the wrong section, wasn't sure if it should go in mods or general. I am interested in changing out the stock headlight bulbs to HID's. I have some Plug and Play kits in my truck that were literally just plug and play. Are these the same for the bikes too? I seen a few forum...

Hello, I am currently stuck abroad as my trip was detoured by some malfunction. The timeline of events: -yesterday I saw the check engine light flash for 1s while going over a bump -today I saw the highbeam led flash for 1s when starting the bike -rode for about 100km- -let the bike sit...

So my plug caps resistance all measure quite differently so would like to replace them but stock are not cheap Is there an NGK alternative that fits well?

Hey Guys been busy with the bike got some bad gas and fried a plug or two. Anyways got the plugs changed, drained the radiator while I was in there and I also pulled a wire out while I was draining the tank it fell and pulled it loose from the plug at the bottom of the tank. Everything runs...

I'm sorry for the abrupt question, but I just had a hell of an afternoon. I tried to do a spark plug change for my bike, and I'm not sure why, but after it was all installed, the idle was really rough and something was obviously wrong (the bike was jerking and misfiring, it seems). I ripped it...

Long story short. I've been chasing a vib, very high frequency,definitly engine RPM related. After many checks, adjustments, re-setting engine position-torque, sync, etc, I found the issue... After doing a spark plug wire shortening(didn't need it, no arcing, two slightly loose) I...

I did do a partial search but couldn't find what I've seen here in the past. I'm looking for a particular TOG. I believe the TOG also wrapped partially around the lower frame "arms" making for a much stronger mount. (cradling it). The "cages" are Ok but limited access to the filter...

Got the old girl patched up a little more after some electrical issues. New R/R, plugs, and battery seems to have fixed her up and she's peppy as ever. My 2nd cylinder spark plug had burn marks on the white ceramic part, which makes me suspect it wasn't seated fully. The threads in the plug...

Hello everyone! I tried installing a dual H4 mod and the lights are acting weird. I realize that I didn't know enough about what I was doing to attempt this. Water under the bridge now. Here's the deets: I bought a 100 watt power relay that plugs into the stock H4 plug coming from the...

Hi guys and gals I hope you're all well? I thought I'd post to save you from possibly wasting money on a magnetic sump plug. I bought one from eBay for £7 and the magnet is so weak it won't even stick to my fridge and barely lifts a 10mm long screw! If they're all like this they're a...

Sold! Literal plug & play keyless ignition system by Digital Guard Dawg. I had this installed on my 2007 model using all stock connectors. The kit comes as a universal installation in stock form; I added stock ignition wire connectors and purchased a second stop switch assembly in order to make...

So I just finished installing my naked kit off of eBay on my fz6. I used the high beam bulb from the old headlights and took one of the wires out of the high beam plug in and put it in the low beam plug in allowing me to use the high and low beam switch. While I was riding around my neighborhood...

Hey guys! I need a little help. Last year, I completely disassembled the front of my 2008 Yamaha FZ6 Fazer because it was wrecked and I was thinking about a Naked conversion. Well, I decided against the Naked conversion and repaired the fairing instead. But there is this one wire...

Hey everybody, I'm new to the forum, so sorry if this is discussed elsewhere... I just pulled the engine out my my 2004 FZ6 for a very minor repair (last owner snapped the spark plug wire housing off inside the engine which has made it impossible to swap out the plug. And yes, I tried to fish...

Hi all. I have a question about magnetic drain plugs. I've been tempted to use one just to see if any crud comes out with it. Not that I expect anything but more so out of curiosity. My only issue is that it's really long compared to OEM plug and I don't know if that extra 0.5 cm will touch...

I got the givi engine guards and I like them but they block the oil drain plug. Ground down as much of the engine mount bolt as I feel comfortable with (actually the head not the threaded part) and I tried it with spacers but still can't get the drain plug out without loosening everything on the...

. . . . . . . . . . Figure it out yet? . . . Although this was solved some time ago, a picture brings it home right! That is the infamous "WEEP HOLE" which connects all spark plug galleys allowing water and oil (God forbid) to drain from the spark plug boot area should the caps allow moisture in...

Hello everyone! Fairly new FZ6 owner here who just purchased the bike back in August. I have been having a rather problem free run up until a few weeks ago when the bike refused to start after sitting in the rain for a day or two. The bike displays "Er-1" when trying to start it up. The bike...